Visual discomfort

- Adjusting the IPD setting to match the distance between your eyes is important for a comfortable experience
- Choose a lens / headmount setting in Trinus PC server that suits your headset (you can also disable Lens Correction)
- Bad head tracking can also cause discomfort. Try calibrating your phone's sensor prior to use. Test the alternative sensor options

BSOD

- Some users have reported a Windows crash when connecting via USB. This is usually solved by disabling Fast Boot option in Windows

There are a few settings in the Trinus VR Android client that can help sort certain issues or improve the VR experience:

Video Port: Main connection port as set on the Trinus VR PC server. Default is fine unless you get port already in use issues

Sensor Jitter Filter: To reduce jitter caused by some phone's sensors

Sensor Drift Filter: Might reduce orientation drift, you can also try changing the Sensor Mode

Sensor Mode: Different ways to manage sensor data. Switch if default creates a lot of drift / doesn't work

Flip View Vertically: Enable view flip when rotating the phone

VR Menus: Trinus itself will be in VR mode, to control with headset on. Clear app data if you can't restore to non-VR Menus

Internet Check: Using a tethered connection may cause your PC to attempt to go online using mobile data. Trinus will notify you to avoid mobile fees, but you can disable such notification ​with this option

Fake Roll: Choose roll direction when Fake Roll is enabled (for non-VR games)

Lens Correction: Lens correction distorts the image to match the lenses in your headset. Disabling it can improve performance at the cost of image quality

Performance level: Set priority between quality and speed

Connect To Trinus Wifi On Start: If active, the phone wil try to connect to the Trinus hotspot automatically. This is one of the ways to connect Trinus, but only available in certain hardware configurations. And still not as fast as USB

With SteamVR installed (but not running), start Trinus and select SteamVR mode.
Trinus will install the SteamVR driver (check for errors in the notifications area).

Then you can start SteamVR and the Room setup.

Note that SteamVR games that require VR controllers have limited compatibility (through NoloVR or PSmove).

For best results, you will need to adjust quality settings to match your setup. Here are some suggestions:

- Decrease the game resolution, either through game setup or Trinus image size option

- Connect your Android device via USB Tethering (may require manufacturer's specific driver to get max performance). Note that some telecoms may disable USB Tethering

- Routers provided by ISPs are not always very high performance for local networking, consider using USB or a separate router (that supports AC) for Trinus

- Use Fake3D mode (with game resolution ratio at 4:3 or 8:9, not landscape 16:9)

- Try the different capture modes (Game and General usually work best, but General may require game to be windowed)

- Enable Fast Scaling (image quality will be lower, but you'll get a performance boost)

- Check the rates shown on the top right corner (frame capture/frame delivery/sensor data rates). A low capture rate means low performance on the PC side. Low delivery rate means low performance on the network

- If using GearVR, you'll need an app that disables the Oculus service (effectively turning it into a Google Cardboard headset). You can use this one, for example. Alternatively, you can try to put the phone in without plugging the USB port

- You can read more about each setting by hovering over it with the mouse (contextual help on the right)

- You can also find solutions to common problems in the forum or Reddit